DISCLAIMER:This item is subject for inventory availability verification.There may be cases where you have been able to order a product and we will run out of stock before we can update our store. In the event of this case, our customer service team will contact and notify you via email.  

Scale: 1/32
Wingspan: 13.63"
Length: 15.5"
Code: AP47TE

 
This collectable model P-47 Thunderbolt represents an early the “Jug” – a tough fighter that began the air war in Europe as a bomber escort and later became the primary fighter-bomber of the theater. This 1/32-scale model P-47B Thunderbolt makes a great pilot gift or a present for any veteran, aviation enthusiast or history buff.

The P-47 Thunderbolt was one of the largest single-engine fighters of the war, an airframe built around a powerful R-2800 radial engine of 2,500 horsepower. Armed with eight .50-caliber machine guns and able to carry up to 2,500 pounds of bombs or 10 5-inch rockets, the Thunderbolt was fast, tough and effective. The “razorback” P-47 Thunderbolts had a tall fuselage spine behind the pilot, compromising visibility. Later versions featured the bubble canopies, as well as the additional of a dorsal fin to remedy a lateral instability caused by the removal of the razorback.

Service deliveries of the P-47 began in 1942, with its first combat mission on March 10, 1943. The Thunderbolt found air-to-air success, with tactics that took advantage of its ability to dive, then zoom-climb to regain energy. The P-47 shot down more than 3,700 enemy aircraft, then struck fear into Wehrmach formations as the ground war in Europe began again in 1944. Its ability to deliver bombs or rockets, as well as being a potent strafing platform severely hindered the movement of German units. The P-47 served briefly with the Strategic Air Command following World War II. A number of P-47 remain flyable, and can often be seen and exhibits and air shows.
 
The P-47B not only led to the P-47C but to a few other "one off" variants. A single reconnaissance variant designated RP-47B was built. In September 1942, the 171st and last P-47B (41-6065) was also used as a test platform under the designation XP-47E to evaluate the R-2800-59 engine, a pressurized cockpit with a hinged canopy and, eventually, a new Hamilton Standard propeller. The plans for production were cancelled after increased emphasis on low-level operations over Europe.  Another P-47B was later fitted with a new laminar flow wing in search of higher performance and redesignated XP-47F.